Installing Drive Gear.

TM 5-4210-224-14&P

6-19. TRANSMISSION REPAIR. (Continued)

c. Installing Drive Gear.

(4)

Install snap ring (27) on inside diameter of

mainshaft pilot bearing bore in clutch gear.

CAUTION

Exercise care to prevent distortion

of the oil slinger.

(5) Apply a small amount of grease (Appendix D,

Item 15) to bearing surface in the shaft recess.

(1) Press bearing (26) and new oil slinger (15) onto

drive gear shaft (14) using driver gear bearing

NOTE

remover/installer. Slinger should be located

This roller bearing retainer holds

flush with bearing shoulder on drive gear.

bearing in position and in final

transmission assembly, is pushed

(2) Install snap ring (28) to secure bearing (16) on

forward into recess by mainshaft

drive gear shaft (15).

pilot.

(3) Install bearing retainer ring (14) in groove on

(6)

Install transmission mainshaft pilot roller

outside diameter of bearing (16). The bearing

bearings (26) and install roller bearing retainer

must turn freely after it is installed on the shaft

(31).

(15).

6-41