Quantcast INSPECTION - TM-5-4210-224-14-P0529

 

Click here to make tpub.com your Home Page

Page Title: INSPECTION
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Transmission Cover Disassembly.
Up
TM-5-4210-224-14-P 250 6PM Mini-Pumper Firefighting Truck Model No.:CM-KFT-3 Manual
Next
Synchronizer and Springs Repair.
TM 5-4210-224-14&P
6-19. TRANSMISSION REPAIR. (Continued)
c. Front and Rear Bearings Inspection.
INSPECTION
WARNING
WARNING
Cleaning solvent is both toxic and
Cleaning solvent is both toxic and
flammable.  Use only in a well-
flammable.  Use only in a well-
ventilated area. Keep off skin and
ventilated area. Keep off skin and
avoid  prolonged  breathing  of
avoid  prolonged  breathing  of
vapors.
Keep away from open
vapors.
Keep away from open
flame.
flame.
a. Transmission Case Inspection.
(1)
Wash front and rear bearings thoroughly in
cleaning solvent (Appendix D, Item 44).
(1)
Wash transmission thoroughly inside using
solvent (Appendix D, Item 44).
(2) Blow out bearings with compressed air.
(2) Inspect transmission case for cracks. Replace if
WARNING
damaged.
Compressed air used for cleaning
(3) Wipe the magnetic disc with a clean, lint-free
or  drying  can  create  airborne
cloth (Appendix D, Item 12).
particles that may enter the eyes.
Pressure shall not exceed 30 psi
NOTE
(206 kPa). Wearing of goggles is
The magnetic disc is glued in
required  to  avoid  injury  to
place.
personnel.
(4) Check front and rear faces for burrs.
(3)
Lubricate bearings with light engine oil
(Appendix D, Item 23) and check them for
b. Roller Bearing and Spacers Inspection.
roughness by slowly turning the race by hand.
(1) Closely inspect all bearing rollers and replace
d. Gears Inspection.
them if there is any indication of wear.
(1) Inspect all gears for excessive wear, chips, or
cracks.
(2)
Inspect spacers and replace any worn ones.
(2) Replace any gears that are worn.
(3) Check clutch sleeves to ensure they slide freely
on their hubs.
6-37

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.