INSTALLATION - TM-5-4210-224-14-P0515

TM5-4210-224-14&P

6-15. REAR CRANKSHAFT SEAL MAINTENANCE. (Continued)

NOTE

CAUTION

Install the main bearing cap bolts,

To prevent damage to the main bearing

torque the inner bolts to 110 ft-lbs (150

caps, the caps are to be tapped into the

N m) and the outer bolts to 100 ft-lbs

block using a brass or leather mallet.

(150 N-m) in sequence.

The new seal is used as a guide. The

cap must not be pulled into the block

i. Install oil pump (paragraph 6-14).

with the bolts.

j. Retighten all bolts using the same sequence.

The contact ends of the seal halves

should now be at the four and ten

k. Install oil pump. (paragraph 6-14)

o'clock positions. This is necessary to

align the rear main bearing cap and

seal lips.

f. Apply a thin film of anaerobic sealant (Appendix

D, Item 40) to the main bearing cap (1), being

careful not to put sealant in the bearing cap oil

relief slot.

g. Apply engine oil Appendix D, Item 23) to the

main bearing cap bolt threads.

h. Tap the main bearing cap into place with a

brass or leather mallet.

6-23