5-9. ALTERNATOR REPAIR (Continued).
g. Support the slip ring end housing (22) on an arbor press. Slip the rotor (19) to the drive end housing (20) through
the stator (21) and into the slip ring end of the housing.
h. Install three through bolts (18), lock nuts (17), and tighten nuts.
i. Install the regulator (8) and br hes (36) in the housing.
j. Connect jumpers (24) and tighten nuts (9 and 10).
k. Push and pin the brushes (36) in place.
l. Install regulator brush holder housing assembly (13) and install four brush housing screws (14). Coat with Loctite
(Appendix D, Item 21).
m. Install nuts (9 and 10) on output terminals (11 and 12) and connect diode lead (7).
n. Install fan spacer (6), drive key (5), fan (4), and pulley (3) to the regulator (8).
o. Install washer (2) and shaft nut (1).