INSTALLATION - TM-5-4210-224-14-P0450

TM 5-4210-224-14&P

g. Remove seal (13).

h. Install knuckle onto the king pin (8).

h. Remove retainer (14), race (15), bearing (16),

i. Place bushing (9) over the king pin (8).

and seal (17) from the axle yoke (12) all at

once.

j. Install bearing ca and king pin (3) to the

steering knuckle (11) using four bolts (1) and

i. Discard old seal (17).

washers (2).

j. Discard retainer (14) if damaged.

k. Torque bolts (1) alternately and evenly to 80 ft-

lbs (108 N m)

INSTALLATION

l. Install compression spring (5), gasket (7) and

steering arm (6) to steering knuckle (11) using

a. Install new retainer (14) and race (15) using

nuts (4).

front pinion bearing installer.

m. Torque nuts (4) alternately and evenly to 80 ft-

b. Fill the area in the retainer (14) and race (15)

lbs (108 N.m).

with grease (Appendix D, Item 15).

n. Install spindle (paragraph 4-236).

c. Grease bearing (16), packing the grease

between the rollers, cones, and cage.

o. Install wheel, hub, rotor (paragraph 4-233).

d. Install bearing (16) and seal (17) using king pin

p. Install locking hub (paragraph 4-253).

bearing seal installer.

q. Adjust wheel bearings (paragraph 4-234).

NOTE

Seal will protrude slightly from the

r. Install wheel and tire assembly (paragraph 4-

surface of the axle yoke flange

203).

when fully seated.

s. Check front end alignment.

e. Install upper king pin (8), torque to 550 ft-lbs

(745 Nm).

t. Lower vehicle to the ground.

f. Tighten steering knuckle (11) and bushing (9).

g. Install felt seal (13) to the king pin (8) through

the steering knuckle (11).

4-355