TM 5-4210-224-14 & P
4-233. WHEEL HUB/ROTOR REPLACEMENT. (Continued)
j. Install the adjusting nut (4).
k. Adjust the wheel bearing.
Put an additional quantity of
l. Install ring (3) and locking nut (2).
grease outboard of this wheel
Tang on the inside diameter of the
g. Install new seal (11).
ring must pass onto the slot on the
spindle (12). The hole in the ring
must align with the pin on the lock
Use a flat plate to install the seal
nut (2). Move the adjustment nut
so it is flush with the rotor/hub
(4) to align the pin.
flange, lubricating the seal lip with
a thin layer of grease.
m. Using the wheel bearing nut wrench and the
torque wrench adapter, torque the lock nut (2) to
h. Install the rotor/hub (8).
160 ft-lbs (217 N.m).
n. Install the locking hub (1).
o. Install the caliper.
p. Install the wheel and tire.
q. Lower the vehicle to the ground.
i. Install the outer wheel bearing (5) by pressing
on the spindle until the wheel bearing fully seats
against the rotor/hub outer race.
4-234. WHEEL BEARING ADJUSTMENT.
This task covers:
General Mechanics Tool Kit
Wheel Assembly Removed
Disc Brake Lining Removed
Manual Locking Hub Removed