TM 5-4210-224-14 & P
4-219. REAR DRUM BRAKE REPLACEMENT. (Continued)
Be sure that the strut (10) is
without the spring engages the
parking brake lever. The end with
the spring engages the opposite
j. Install the actuator lever (6) and lever pivot (7)
with the actuator link (9) and lever return spring (8).
k. Install the hold down pins (5) and hold down
a. Position wheel cylinder (21) and attach with
l. Install the shoe guide (3) and return springs (1
b. Torque bolts to 160 in-lbs (18 N.m).
m. Install the drum by aligning the marks made
c. Connect inlet tube line and install links (19).
d. Torque inlet tube nut to 200 in lbs (22.6 N.m).
n. Install the wheel and tire assembly by aligning
the marks made during disassembly (paragraph 4-203).
e. Lubricate the adjusting screw threads with a thin
coat of white lithium grease (Appendix D, Item 16).
o. Adjust the brakes.
f. Install the adjusting screw assembly (17) and
adjusting screw spring (18) to both shoes (15 and 16).
(1) Remove the lanced area in the brake
g. Install the shoe assembly.
(2) Adjust the brake adjusting screw until the
h. Install the parking brake lever (13) and washer
wheel can just be turned by hand.
(14) into the shoe and secure with the retaining ring
i. Place strut spring (11) onto the parking brake
The brake drag should be equal at
strut (10) and install by spreading the shoes (15 and 16)
(3) Back off the adjusting screw 33 notches.