4-215. STOP LIGHT SWITCH REPLACEMENT
This task covers:
General Mechanics Tool Kit
General Safety Instructions
Transmission in (N) neutral.
Parking brake and micro-brakelock set.
a. Disconnect the electrical connectors at the
brake pedal (2) mounting bracket (3).
b. Remove the switch (1).
a. Install the switch (1).
b. Connect the electrical connector.
c. Depress the brake pedal (2) and press the
switch (1) in until it is firmly seated in the clip
Audible clicks can be heard as the
f. Electrical contact should now be made when the
threaded portion of the switch is
brake pedal is depressed 1 to 1.24 inches (25-
pushed through the clip.
31 mm) and the brake lights should go on.
d. Pull the brake pedal (2) fully rearward against
g. Check the operation of the switch.
the pedal stop until the audible clicks can no
longer be heard.
e. Release the brake pedal (2), then repeat step c
to assure that the switch is properly seated and
no audible click can be heard.