INSTALLATION - TM-5-4210-224-14-P0182

TM 5-4210-224-14&P

4-53. REAR PLATFORM AND STEPS REPLACEMENT (Continued).

acorn nuts (8), five hex nuts (3) and four wire

f. Remove end panel (6) and platform (5) from

holders.

vehicle.

e. Connect rear panel signal switch (9) to end

g. Remove folding steps (10) from end panel by

panel (6).

removing two screws (1) and cap nuts (8) from

panel (6).

f. Install two screws (1), flatwashers (2),

lockwashers (4) and nuts (3) securing bottom of

INSTALLATION

end panels (6) to rear platform (5).

a. Install folding steps (10) to end panel with two

screws (1) and cap nuts (8).

g. Install nine screws (1), flatwashers (2),

lockwashers (4), and nuts (3) securing rear

b. Position and install rear platform (5) to vehicle.

platform (5) to support rails (7).

c. Install three screws (1), flatwashers (2),

h. Install handrails (paragraph 444).

lockwashers (4) and nuts (3) securing underside

of rear platform (5) to bottom of compartment

i. Install hose bed pick-up lights and brackets

panels on each side of vehicle.

(paragraph 4-48).

d. Position and install end panel (6) to hose bed

j. Reconnect battery cables.

body with seven screws (1), washers (2), two

4-54. REAR STATION CHARGER REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Tools

General Safety Instructions

General Mechanics Tool Kit

Engine OFF

Transmission in (N) neutral.

Materials/Parts

Parking brake and micro-brakelock set.

Station Charger (5378)

Batteries disconnected

REMOVAL

a. Remove two screws (1) securing rear station

charger (2) to vehicle.

b. Pull station charger (2) outward and disconnect

wiring.

4-87