 |
|||
|
|
|||
|
Page Title:
LUBRICATION INSTRUCTIONS - continued |
|
||
| ||||||||||
|
|
 TM 5-4210-224-14&P
4-9. LUBRICATION INSTRUCTIONS (Continued).
(3) Fluid Recommendations.
c. Clutch Lubrication (Continued).
(a)
Dexron, Dexron II and type C-3 oils
(4) Clutch System Bleeding.
(DDA approved SAE 10 W or SAE
30) are recommended for use in the
(a)
Remove two secondary cylinder
transfer case (Appendix D, Item 32).
mounting bolts (3).
Remove
(b)
Type C-3 oil is the only fluid
secondary cylinder (4).
approved for use in off-highway
applications.
NOTE
(c)
Use type C-3 SAE 30 (Appendix D,
Check and refill reservoir as
Item 31) in all applications where
needed while bleeding so air will
ambient temperature is consistently
not be drawn into the system.
above 85 (300C).
F
(d)
Some Dexron II fluids are also
(b)
Hold the clutch pedal down, open the
qualified as type C-3 oils and may be
bleeder screw (5) to let air and fluid
used in off-highway applications.
escape. Close bleeder screw (5).
However, a Dexron fluid which is not
Let clutch pedal up. Repeat step (b)
a qualified type C-3 oil is not
until all air is out of system.
approved for use in off-highway
(c)
Install the secondary cylinder (4) and
applications.
mounting bolts (3).
Tighten
mounting bolts to 13 ft.-lbs. (18
N ). Refill as needed.
m
d. Transfer Case Lubrication.
(1) Oil Level Check. Remove fill plug (1) and
inspect the level of the transfer case
assembly. Fluid level should be filled
approximately one inch below fill plug (1).
(2) Adjusting Oil Level. With fill plug (1)
removed, fill transfer case with DEXRON
II fluid (Apprendix D, Item 32). Fill until
fluid level is approximately one inch
below fill plug hole. Replace fill plug (1).
Torque to 32 ft-lbs (44 N ).
m
4-17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals