|
| |
TM 5-4210-220-34
2-19.
ENGINE - Continued
2-19.12
Throttle, Fuel Shutdown, And Fire Pump Governor - Continued
(2)
Tag and remove water and air lines at connections (4 and 5).
(3)
Tag and remove ground wire from fuel water separator.
(4)
Remove bolts (6), and washers (7) and lift pump governor from engine.
(5)
Assemble pump governor as shown. Be sure bracket (8) is installed on the end of the air side control rod so
that the threads of rod (11) are just seen out of nut (9).
(6)
Be sure bracket (8) is held firmly in place with nuts (9 and 10).
(7)
While holding bracket (8) up against left-hand bracket (A) back off nut (13) and rotate shaft (12) until
diaphragm in water chamber bottoms out. Lock control rod nut (13) against end of rod (11).
(8)
Aline assembly on engine and install screws (6) and washers (7). Tighten securely.
2-246
|
