|
| |
TM 5-4210-220-34
2-19.
ENGINE - Continued
2-19.12
Throttle, Fuel Shutdown, And Fire Pump Governor - Continued
(7)
Loosen screws (19), and nuts (20) until throttle arm (14) is loose.
(8)
Remove screws (21) and lift plate (13) from engine.
(9)
If a new shutdown plate is being installed, carry out instructions 10 thru 12. If the old plate is being installed
on an old engine go to step 13.
(10)
Remove second solenoid mounted on plate (A) from new shutdown plate (13).
(11)
Remove throttle spring (22). Remove nuts (23) and bolts (24) and lift throttle cylinder and speed arm
assembly from old plate.
(12)
Install throttle cylinder (9) and new plate (13) using nuts (23) and bolts (24). Install throttle spring (22).
(13)
Aline throttle speed arm (14) with governor shaft and install shutdown plate on governor. Remove screws
from governor top plate as required.
(14)
Install pump governor arm (10) over governor speed shaft. Do not tighten the retaining screws.
(15)
Install stop control arm (12) on stop shaft. Do not tighten the retaining screws.
2-244
|
