Items that are included in kits and sets are listed below the name of the kit or set.
Spare/repair parts that make up an assembled item are listed immediately following the assembled item
Part numbers for bulk materials are referenced in this column in the line item entry for the item to be
When the item is not used with all serial numbers of the same model, the effective serial numbers are
shown on the last line(s) of the description (before UOC).
The usable on code, when applicable (see paragraph 5, Special Information).
In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the entry for each
special tool, special TMDE, and other special support equipment. When density of equipments
supported exceeds density spread indicated in the basis of issue, the total authorization is increased
The statement "END OF FIGURE" appears just below the last item description in Column 5 for a given
figure in both Section II and Section III.
The indenture, shown as dots appearing before the repair part, indicates that the item is a repair part of
the next higher assembly.
QTY (Column (6)). The QTY (quantity per figure column) indicates the quantity of the item used in the
breakout shown on the illustration figure, which is prepared for a functional group, subfunctional group, or an assembly.
A "V" appearing in this column in lieu of a quantity indicates that the quantity is variable and may vary from application to
EXPLANATION OF COLUMNS (SECTION IV).
NATIONAL STOCK NUMBER (NSN) INDEX.
STOCK NUMBER column. This column lists the NSN by National item
(NIIN) sequence. The NIIN consists of the last nine digits of the
NSN, i.e. (5305-01-574-1467).
When using this column to locate an item, ignore the first 4 digits of the NSN. However, the complete
NSN should be used when ordering items by stock number.
FIG. column. This column lists the number of the figure where the item is identified/located. The
figures are in numerical order in Section II and Section III.