|
| |
TM 5-4210-220-12
4-24. ELECTRICAL SYSTEM - Continued
4-24.8 Truck Lights - Continued
g.
Rear Emergency Lamp Replacement
NOTE
Only the lens is replaceable.
(1)
To remove lens (1), unscrew lens.
Replace with new gasket (2).
(2)
To replace lamp, remove screws (3).
(3)
Lift lamp from base and cut wires at butt
connector.
(4)
Join new lamp wires to harness with butt
connector.
(5)
Install new lamp using screws (3). Do not
overtighten.
h.
Rear Deck Lights Replacement
(1)
To replace sealed beam, remove ring
mounting screw (3).
(2)
Pull ring (1) forward, sealed beam is held
in ring with springs (2).
(3)
Pull wire connectors from back of sealed
beam.
(4)
Remove springs (2) and replace lamp.
(5)
Install springs (2) to secure lamp to ring
(1).
(6)
Offer up ring assembly to lamphead.
Install connectors on to terminals of lamp.
(7)
Push ring into lamphead, ensure lower lip
on ring alines with lamphead indent.
(8)
Secure ring with screw (3).
(9)
To replace rear deck light, remove screws
(4) securing lamp to hose body.
(10)
Cut wire to lamp adjacent to butt
connector. Cut butt converter from
harness.
4-442
|
