|
| |
TM 5-4210-220-12
4-12. CAB - Continued
4-12.6 Transmission Shift Control - Continued
NOTE
Cable brackets (4) and (5) do not
normally require adjustment. They
may be repositioned if the length of
new cable sheathing differs from the
old. Typically the length (A) is
adjusted to 6.8 in. (173 mm).
(11)
Line up fittings (2 and 6) with mounting
holes in shift control and transmission shift
arm respectively. Move swivel fittings
further in or out on the threaded cable buds
to achieve this.
(12)
Install swivel fittings to shift control and
transmission shift arm and secure with
cotter pins.
(13)
Select in turn, 1st and reverse gears using
the shift control lever. The transmission
shift shaft has detents in all gear positions.
Be sure that the detents in the two extreme
positions fully engage.
(14)
Be sure that when either 1st or reverse gear
is selected, no undue stress is exerted on
swivel fittings (2 and 6). If necessary
remove fitting from transmission arm of
shift control and readjust position on cable.
Reinstall after adjustment.
(15) Install
control
panel
containing
transmission shift control as detailed in
INSTALLATION preceding.
4-98/(4-99 Blank)
|
