|
| |
TM 5-4210-218-13&P
5-4. TILT RACK ASSEMBLY REPAIR. (Refer to Figure 5-3)
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Condition
Tools
Reference
General Mechanics Tool Box, Item 1, Section
Cover removed from Recovery / Recharger
III, Appendix B.
Unit; paragraph 2-6.1
Materials/Parts
Self-locking nuts
NOTE
The tilt rack assembly consists of angles, channel, plate drilled and bolted plus rod and bearings.
Refer to paragraph 4-16 for removal instructions for angles, channel, and plate, plus rod and
bearings. The remaining angle is addressed here.
5-4.1. Removal. (typical)
a.
Remove two nuts (1), washers (2), bolts (3) and washers (4) holding each end of piece to be replaced.
b.
Remove damaged piece.
5-4.2. Installation. (typical)
a.
Install new piece.
b.
Position and secure with two washers (4) bolts (3), washers (2), and nuts (1) on each end.
5-6
|
