|
| |
TM 5-4210-218-13&P
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
SECTION I. GENERAL
5-1. GENERAL
This chapter contains disassembly, cleaning, inspection, replacement, and assembly instructions for the Recovery /
Recharger Unit assemblies. Except for the transfer pump unit and the control panel the assemblies will have been
replaced at unit level.
SECTION II. MAINTENANCE INSTRUCTIONS
5-2. WINCH ASSEMBLY REPAIR. (Refer to Figure 5-1)
This task covers:
a. Disassembly
b. Cleaning
c. Inspection
d. Assembly
INITIAL SET UP
Equipment Conditions
Tools
Reference
Tool Kit, General Mechanics
Winch Assembly Removed, reference
(Item 1, Section III Appendix B)
paragraph 4-9
Materials/Parts
As required
Solvent (item 7, Section II, Appendix F)
5-2.1. Disassembly.
a.
Remove locknut (1) and slide cap screw (2) from core of drum (3).
b.
Remove drum (3) and frame spacer (4).
c.
Remove retaining ring (5), spring (6) and unscrew handle (7) from pinion shaft (8).
d.
Remove handle disc (9) and retaining ring (10).
NOTE
The next step will allow parts to fall free. Be prepared to catch and retain all parts that are on the
pinion shaft.
5-1
|
