|
| |
TM 5-4210-218-13&P
SECTION V. MAINTENANCE PROCEDURES
4-7 REMOVAL AND REPLACEMENT OF PRINCIPAL ASSEMBLIES.
The following procedures contain instructions to remove and replace principal assemblies of the Recovery / Recharger
Unit. Disassembly, cleaning, inspection, repair, and assembly instructions for direct support maintenance are specified in
Chapter 5.
4-8 HOIST WINCH ASSEMBLY INSTALLATION. (Refer to Figure 4-1)
This task covers:
a.
Installation
INITIAL SETUP:
Equipment Conditions
Tools
Reference
Tool Kit, General Mechanics
Newly received Recovery / Recharger
(Item 1, Section III Appendix B)
Unit; paragraph 4-4.
Materials/Parts
None
4-8.1 Preparation
a.
Remove hoist winch assembly from shipping position.
b.
Loosen two self-locking nuts (1) on each hoist strap (2) located on scale frame. Do not remove nuts.
4-8.2 Installation
a.
Position hoist bearing (4) on floor of base (bearing in tool box).
b.
Slide hoist pipe (3) under both hoist straps (2) and rest on bearing.
c.
Tighten two self-locking nuts (1) on each hoist strap (2).
d.
Check freedom of swing for assembly and proper winch operation (clicking sound when cable being wound).
4-6
|
