|
| |
TM 5-4210-218-13&P
a.
Remove three nuts (4), washers (5), and bolts (6) in face of support frame. Discard nuts.
b.
Remove two nuts (7), washers (8), and bolts (9) securing top of support frame to angle braces (one brace each
side). Discard nuts.
c.
Approximately one-third up on the angled portion of the support frame, remove two nuts (10), washers (11), and
bolts (12) that secure brace to support frame (one brace each side).
d.
Remove support frame (13) and set aside.
5-6.4. Support Frame Installation.
a.
Check replacement frame visually for defects. Do not use if defective.
b.
Position frame (13) making certain angle braces fit on outside of frame at top and braces fit on inside of frame and
bottom of frame is on outside of base assembly.
c.
Install two bolts (6), washers (5), and nuts (4) in support frame and base frame connection and one bolt (6),
washer (5), and nut (4) in support frame and scale frame connection.
d.
Install two bolts (9), washers (8), and nuts (7) to secure top of support frame to angle braces (one brace each
side).
e.
Install two bolts (12), washers (11), and nuts (10) to secure the braces running from the angle braces to the
support frame (one brace each side).
f.
If panel was installed as part of frame, follow component installation instructions in paragraph 5-5.
g.
If panel to be installed, follow instructions in paragraph 5-6.2.
h.
Check system for leaks when installation complete.
5-16
|
