Special Information - TM-5-4210-213-24P0008

TM 5-4210-213-24P

basis of issue, the total authorization is increased

(1) First.

Using the table of contents,

accordingly.

determine the functional group within which the repair

g. Unit of Measure (U/M). Indicates the standard

part belongs. This is necessary since illustrations are

prepared for functional groups, and listings are divided

of the basic quantity of the listed item as used in

into the same groups.

performing the actual maintenance function.

This

measure is expressed by a two-character alphabetical

(2) Second. Find the illustration covering the

abbreviation (e.g., ea, in, pr, etc). When the unit of

functional group to which the repair part belongs.

measure differs from the unit of issue, the lowest unit of

(3) Third. Identify the repair part on the

issue that will satisfy the required units of measure will

illustration and note the illustration figure and item

be requisitioned.

number of the repair part.

h. Quantity Incorporated in Unit. Indicates the

(4) Fourth. Using the Repair Parts Listing,

quantity of the item used in the breakout shown on the

find the figure and item number noted on the illustration.

illustration figure, which is prepared for a functional

b. When National Stock Number or Part Number is

group, subfunctional group, or an an assembly. A "V"

Known.

appearing in this column in lieu of a quantity indicates

(1) First. Using the Index of National Stock

that no specific quantity is applicable, (e.g., shims,

Numbers and Part Numbers, find the pertinent National

spacers, etc.).

stock number or part number.

This index is in

ascending NSN sequence followed by a list of part

4. Special Information

numbers in ascending alphanumeric sequence, cross-

referenced to the illustration figure number and item

Code

Used On

number.

(2) Second. After finding the figure and item

A ................Model M45AWLF

number, locate the figure and item number in the repair

B ................Model M45A2FTL-1

parts listing.

C ................Model FT-500

6. Abbreviations

a. Repair parts kits and gasket sets appear as the

last entries in the repair parts listing for the figure in

ft................................... feet (foot)

which its parts are listed as repair parts or are listed at

in .................................. inch(es)

the end of the repair parts listing for the last figure

Ig .................................. length (long)

containing parts of the kit.

Ih .................................. Ieft hand

b. The following publications pertain to Truck, Fire

mtg ............................... mounting(s)

Fighting and its components:

rh.................................. right hand

TM 5-4210-213-12

Operator and Organizational

7. Recommendations for Maintenance

Maintenance Manual

Publications Improvements

TM 5-4210-213-34

Direct support and General

You can improve this manual by calling attention to

Support

Maintenance

errors and by recommending improvements, using DA

Manual

Form 2028 (Recommended Changes to Publications) or

LO 5-4210-213-15

Lubrication Order

by a letter, and mailing directly to Commander, U.S.

Army Troop Support Command, ATTN: AMSTS-MPP,

5. How to Locate Repair Parts

4300 Goodfellow Boulevard, St. Louis, Missouri 63120.

A reply will be furnished directly to you.

a. When National Stock Number or Part Number is

Unknown: