|
| |
TM 10-4210-235-13
WARNING
Performing maintenance on equipment that is not properly supported can result in equipment
falling or being dropped causing personal injury.
(c)
Using jack and four jack stands, raise and secure frame (35).
(d)
Remove six lock nuts (22) and screws (23). Discard lock nuts.
(e)
Remove six lock nuts (25) and screws (26). Discard lock nuts.
(f)
Remove two stop blocks (4), one pintle (7), and four tie down eyes (10) per steps (1) through (3)
above.
(g)
Remove front jack per paragraph 4-27.
(h)
Remove rear jack stands per paragraph 4-26.
(i)
Remove frame (35).
b.
Repair (See figure 4-33.)
(1)
Repair is limited to replacement of defective or damaged components only.
(2)
Send frame (35) to Direct Support Maintenance for repair.
c.
Assembly (See figure 4-33.)
(1)
Stop block installation.
Install rear stop block (4), screw (3), washer (2), and nut (1).
(2)
Pintle installation.
Install pintle (7), aligned with mounting holes noted during disassembly, two screws (6) and new self
locking nuts (5).
(3)
Tie down eye installation.
Install eye (10), pin (9), and cotter pin (8).
(4)
Axle and springs installation.
NOTE
Rear spring holders are different for left and right side. Be sure to install on proper side as
noted during removal.
(a)
Install two rear spring holders (27) and secure using six screws (26) and new lock nuts (25).
(b)
Install two front spring holders (24) and secure using six screws (23) and new lock nuts (22).
(c)
Install four shackles (21) and secure using two screws (20) and new lock nuts (19).
(d)
Install two springs (18) and secure using four screws (17) and new lock nuts (16).
4-75
|
